Interface Loopback; Interface Mfr - H3C MSR 20-20 Command Reference Manual

666 C 44: L
HAPTER OGICAL
Description
Example

interface loopback

Syntax
View
Parameter
Description
Related command:
Example

interface mfr

Syntax
View
I C C
NTERFACE ONFIGURATION OMMANDS
Use the interface ethernet
enter the corresponding Ethernet sub-interface view.
Use the
undo interface ethernet
sub-interface.
By default, no VLAN is associated to an Ethernet sub-interface.
Note that the VLAN associated with the Ethernet sub-interface of the local device
must be the same as the VLAN associated to the Ethernet sub-interface of the
peer device. Otherwise, packets cannot be transmitted properly. A Layer 3
Ethernet interface can accommodate 1 to 4,096 sub-interfaces.
# Create a sub-interface on Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0.1
[Sysname-Ethernet1/0.1]
interface loopback number
undo interface loopback number
System view
number: Loopback interface number, ranging from 0 to 1023.
Use the interface loopback
the corresponding Loopback interface view.
Use the
undo interface loopback
interface.
display interface loopback.
# Create Loopback 5.
<Sysname> system-view
[Sysname] interface loopback 5
[Sysname-LoopBack5]
interface mfr { interface-number | interface-number.subnumber }
undo interface mfr { interface-number | interface-number.subnumber }
System view
command to create an Ethernet sub-interface and
command to remove the specified Ethernet
command to create a Loopback interface and enter
command to remove the specified Loopback