Apply Output-Interface; Display Ip Policy-Based-Route - H3C MSR 20-20 Command Reference Manual

810 C 61: IP U
HAPTER NICAST

apply output-interface

Syntax
View
Parameters
Description
Related commands:
Examples

display ip policy-based-route

Syntax
View
Parameters
P R C
OLICY OUTING ONFIGURATION
apply output-interface interface-type interface-number [ track track-entry-number ]
[ interface-type interface-number [ track track-entry-number ] ]
undo apply output-interface [ interface-type interface-number [ interface-type
interface-number ] ]
policy-based-route view
interface-type interface-number: Specifies an interface.
track track-entry-number: Specifies a track entry. The track-entry-number is in the
range 1 to 1024.
Use the apply output-interface
matched packets.
Use the
undo apply output-interface
This command is used to specify interfaces (two interfaces at most) to send the
matched IP packets.
Note that:
Two outgoing interfaces at most can be specified for matched IP packets.
■
For non-P2P interfaces (broadcast and NBMA interfaces) such as Ethernet
■
interface, multiple next hops are available, and thus packets may not be
forwarded successfully.
n
Non-broadcast multi-access (NBMA) network adopts the unicast mode to send
packets.
apply ip-precedence, apply ip-address next-hop, apply default
output-interface, and apply ip-address default next-hop.
# Specify Serial2/0 as the outgoing interface for matched IP packets.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-policy-based-route] apply output-interface serial 2/0 track 1
display ip policy-based-route
Any view
None
C
OMMANDS
command to set the outgoing interface(s) for
command to remove the configuration.