Manually Releasing The Brakes - ABB IRB 6700Inv Series Product Manual

2 Installation and commissioning

2.4.4 Manually releasing the brakes

2.4.4 Manually releasing the brakes
Introduction to manually releasing the brakes
This section describes how to release the holding brakes for the motors of each
axis.
Location of brake release unit
The internal brake release unit is located as shown in the figure.
xx1200000964
Releasing the brakes
This procedure details how to release the holding brakes when the robot is equipped
with an internal brake release unit.
1
Continues on next page
68
Action
The internal brake release unit is equipped with
buttons for controlling the axes brakes. The buttons
are numbered according to the numbers of the
axes.
If the robot is not connected to the controller, power
must be supplied to the connector R1.MP according
to the section Supplying power to connector R1.MP
on page 69.
© Copyright 2017 - 2020 ABB. All rights reserved.
Note
Buttons are shown in figure
tion of brake release unit on
page 68.
Product manual - IRB 6700Inv
3HAC058254-001 Revision: L
Loca-