ABB IRB 6700Inv Series Product Manual page 69

2
3
Supplying power to connector R1.MP
If the robot is not connected to the controller, power must be supplied to connector
R1.MP on the robot, in order to enable the brake release buttons.
1
2
Product manual - IRB 6700Inv
3HAC058254-001 Revision: L
Action
DANGER
When releasing the holding brakes, the robot axes
may move very quickly and sometimes in unexpec-
ted ways.
Release of the axis-2 motor holding brakes can
cause the axis 2 to move in opposite direction in
regard to gravity, due to the pushing force from the
balancing device. Current arm load and position of
the lower and upper arm determines the occurring
movement when releasing the holding brakes of
the axis-2 motor.
Make sure no personnel is near or beneath the ro-
bot.
Release the holding brake on a particular robot
axis by pressing the corresponding button on the
internal brake release unit.
The brake will function again as soon as the button
is released.
Action
DANGER
Incorrect connections, such as supplying
power to the wrong pin, may cause all
brakes to be released simultaneously!
Supply 0V on pin 12 and 24V on pin 11.
© Copyright 2017 - 2020 ABB. All rights reserved.
2 Installation and commissioning
2.4.4 Manually releasing the brakes
Note
In the example below, with no arm
load and in synchronization posi-
tion, the pushing force from the
balancing device will cause the
lower and upper arm to move for-
wards/upwards, when the brakes
of the axis-2 motor are released.
xx1700000522
Note
xx0600002937
Continued
69