ABB IRB 6700Inv Series Product Manual page 84

2 Installation and commissioning
2.6.1 Robot cabling and connection points
Continued
Fan cables (option)
These cables are not included in the standard delivery, but are included in the
delivery if the fan option is ordered. The cables are completely pre-manufactured
and ready to plug in.
Cabling to be installed on the robot is specified in section
cooling fan (option) on page
Cabling between robot base and control cabinet, cooling fans
The cables specified below are specific for the IRC5 controller and used when the
robot is equipped with cooling fans. The cabling for the cooling fans runs all the
way from the robot base to the inside of the cabinet. Fans can also be ordered
without cables.
If equipping the robot with cooling fans, use the cabling specified below. The cables
for cooling fans listed below are used together with a distributing cable, also
specified below.
Cable
Harness - cooling, 7 m
Harness - cooling, 15 m
Harness - cooling, 22 m
Harness - cooling, 30 m
84
Note
How to ground DressPack/SpotPack cables is detailed in the Product
manual - DressPack/SpotPack IRB 6700, see the document number in
on page 10.
© Copyright 2017 - 2020 ABB. All rights reserved.
86.
Art. no. Connection point
3HAC022723-001 Distributing cable: R1.FAN.SW2/3
Inside cabinet: A43.X10 and A43.X11
3HAC022723-004 Distributing cable: R1.FAN.SW2/3
Inside cabinet: A43.X10 and A43.X11
3HAC022723-005 Distributing cable: R1.FAN.SW2/3
Inside cabinet: A43.X10 and A43.X11
3HAC022723-006 Distributing cable: R1.FAN.SW2/3
Inside cabinet: A43.X10 and A43.X11
References
Installing the motor
Product manual - IRB 6700Inv
3HAC058254-001 Revision: L