ABB IRB 6700Inv Series Product Manual page 90

2 Installation and commissioning
2.7.2 Installing the motor cooling fan (option)
Continued
7
8
9
10
11
Continues on next page
90
Action
Run the cable out through the side of the frame,
at the axis-1 motor and connect the fan cable
connector to the cooling fan.
Strap the fan cable to the axis-1 and axis-2 motor
cables.
Refit the frame cable clamp with the screws.
Connect the connector R1.SW2/3 to the base of
the robot.
Make sure that the cabling, run through the frame
and base, is not twisted and runs freely from the
robot cabling.
Refit the rear cover plate to the robot base.
© Copyright 2017 - 2020 ABB. All rights reserved.
Note
B
A
xx1800000165
A Fan cable connector
B Cable straps
xx1300000542
xx1800000167
xx1800000161
Product manual - IRB 6700Inv
3HAC058254-001 Revision: L