ABB IRB 6700Inv Series Product Manual page 245

6
7
8
9
Refitting the cable harness - lower arm
1
Product manual - IRB 6700Inv
3HAC058254-001 Revision: L
Action
Refit the o-ring.
Tip
Lubricate the o-ring with some grease for
a better fitting in the groove.
CAUTION
When fitting the motor cover, make sure
that none of the cables inside will be dam-
aged.
Refit the motor cover with its attachment
screws.
Note
Do not reuse the self-threading attachment
screws. Replace with standard attachment
screws or the threads will be damaged.
Note
Make sure the o-ring is undamaged and
properly fitted.
Make sure that the covers are tightly
sealed.
Action
Tip
Use tape and tie the axis-5 and axis-6
connectors and carrier into a bundle (if not
already done). This is done to facilitate the
procedure and to avoid damaging the parts
during the procedure.
This will also make it easier to run the cable
harness through the inside of the robot.
© Copyright 2017 - 2020 ABB. All rights reserved.
4.4.2 Refitting the cable harness
Note
Attachment screws: M5x12 8.8 (7 pcs)
xx1200001135
Note
xx1300000668
Continues on next page
4 Repair
Continued
245