ABB IRB 6700Inv Series Product Manual page 30

1 Safety
1.4 Installation and commissioning
Continued
The power supply wiring to the robot must be sufficiently fused and if necessary,
it must be possible to disconnect it manually from the mains power.
The power to the robot must be turned off with the main switch and the mains
power disconnected when performing work inside the controller cabinet. Lock and
tag shall be considered.
Harnesses between controller and manipulator shall be fixed and protected to
avoid tripping and wear.
Safety devices
The integrator is responsible for that the safety devices necessary to protect people
working with the robot system are designed and installed correctly.
When integrating the robot with external devices to a robot system:
Other hazards
A robot may perform unexpected limited movement.
The risk assessment should also consider other hazards, such as, but not limited
to:
Continues on next page
30
Note
Use a CARBON DIOXIDE (CO
• The integrator of the robot system must ensure that emergency stop functions
are interlocked in accordance with applicable standards.
• The integrator of the robot system must ensure that safety functions are
interlocked in accordance with applicable standards.
WARNING
Never stay beneath a robot arm. Gravity and the release of braking devices can
create additional hazards.
WARNING
Manipulator movements can cause serious injuries on users and may damage
equipment.
• Water
• Compressed air
• Hydraulics
© Copyright 2017 - 2020 ABB. All rights reserved.
) extinguisher in the event of a fire in the robot.
2
Product manual - IRB 6700Inv
3HAC058254-001 Revision: L