Halt - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

halt

Syntax
Release Information
Description
Options
Mode
674
The syntax of the command depends on whether you enter it from Boot mode or Privileged
Exec mode.
From Boot mode:
halt
From Privileged Exec mode:
halt [ force | primary-srp [ force ] | standby-srp [ force ] ]
Command introduced before JunosE Release 7.1.0.
Stops operation on both SRP modules or on the specified SRP module. When the high
availability state is active or pending, this command ensures that the router configuration,
up to when you issued the halt command, is mirrored to the standby SRP module. There
is no no version.
CAUTION: To prevent corruption of NVS, issue this command before you remove or
power down an SRP module.
force—Prompts the user to confirm that the router should stop operation if the SRP
modules are in certain states, such as writing configuration data to NVS, that could
lead to loss of configuration data or corruption of NVS.
CAUTION: When the high availability state is active or pending, issuing the force keyword
does not guarantee that the configuration has been mirrored; recent configuration
changes may be lost if you issue the force keyword.
primary-srp—Stops operation on primary SRP module only
standby-srp—Stops operation on standby SRP module only
Boot, Privileged Exec
Copyright © 2010, Juniper Networks, Inc.