Ipv6 Address Cellular-Alloc; Lte Band - H3C MSR810 Command Reference Manual

[Sysname-Eth-channel2/4/0:0] ip address cellular-alloc
Related commands

ipv6 address cellular-alloc

ipv6 address cellular-alloc
Use ipv6 address cellular-alloc to enable an interface to obtain an I Pv6 address by using the
modem-manufacturer's proprietary protocol.
Use undo ipv6 address cellular-alloc to restore the default.
Syntax
ipv6 address cellular-alloc
undo ipv6 address cellular-alloc
Default
An interface does not obtain an I Pv6 address by using the modem-manufacturer's proprietary
protocol.
Views
Eth-channel interface view
Predefined user roles
network-admin
Usage guidelines
This command enables an interface to obtain an IPv6 address from the modem by using the
modem-manufacturer's proprietary protocol, use the ipv6 address cellular-alloc command.
To enable an interface to obtain an I P address from the modem by using DHCP, use the ipv6
address dhcp-alloc command.
The IPv6 address of a modem is automatically allocated by the service provider.
Examples
# Channelize Cellular 2/4/0 into an Eth-channel interface. Enable the Eth-channel interface to obtain
an IPv6 address by using the modem-manufacturer's proprietary protocol.
<Sysname> system-view
[Sysname] controller cellular 2/4/0
[Sysname-Cellular2/4/0] eth-channel 0
[Sysname-Cellular2/4/0] quit
[Sysname] interface eth-channel 2/4/0:0
[Sysname-Eth-channel2/4/0:0] ipv6 address cellular-alloc
Related commands
ip address cellular-alloc

lte band

Use lte band to specify a band for a 4G modem.
Use undo lte band to restore the default.
Syntax
lte band band-number
282