Frame Relay Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
F R
RAME ELAY
To create a virtual Frame Relay interface and activate the Frame Relay Interface Configuration mode,
enter the interface frame-relay command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface frame-relay 1
(config-fr 1)#
By default, Frame Relay interfaces are created as point-to-point links. This default setting cannot be
altered. The following command creates the exact same interface as that mentioned above:
>enable
#configure terminal
(config)#interface frame-relay 1 point-to-point
(config-fr 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 2172
encapsulation frame-relay ietf on page 2173
fair-queue on page 2174
frame-relay commands begin on page 2175
hold-queue <value> out on page 2186
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2187
max-reserved-bandwidth <value> on page 2188
qos-policy on page 2189
snmp trap on page 2191
snmp trap link-status on page 2192
60000CRG0-35E
I C
NTERFACE OMMAND
Copyright © 2012 ADTRAN, Inc.

Frame Relay Interface Command Set

S
ET
2171