ADTRAN AOS Version R10.1.0 Command Reference Manual page 2167

Command Reference Guide
connect
Use the connect command to specify a physical interface to connect to the Ethernet in the first mile (EFM)
group. Use the no form of this command to remove the connected interface from the group. Variations of
this command include:
connect e1 <slot/port>
connect shdsl <slot/port>
connect t1 <slot/port>
Syntax Description
e1 <slot/port>
shdsl <slot/port>
t1 <slot/port>
Default Values
By default, no interfaces are connected to the EFM group.
Command History
Release A4.01
Usage Examples
The following example connects the SHDSL interface shdsl 1/1 to EFM group 1:
(config)#interface efm-group 1
(config-efm-group 1)#connect shdsl 1/1
60000CRG0-35E
Specifies that an E1 interface is connected to the group.
Specifies that a single-pair high-speed digital subscriber line (SHDSL)
interface is connected to the group.
Specifies that a T1 interface is connected to the group.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
EFM Group Command Set
2167