Efm Group Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
EFM G C
ROUP
Ethernet in the first mile (EFM) groups are logical interfaces that represent an EFM bonding group.
Interfaces are connected to the EFM group and provide physical links to carry bonded traffic. These groups
are used with the EFM network interface modules (NIM2s).
EFM NIM2s are used by ADTRAN products to provide EFM capabilities across wide area network
(WAN) interfaces. These NIM2 cards enable host devices to participate in existing Metro Ethernet
networks (MENs) that are deployed with EFM technology. The EFM group operates as the MEN port for
the AOS unit, allowing Ethernet virtual connections (EVCs) to be associated logically as a MEN port and
to use the same interfaces for connection with the MEN.
EFM groups are created and configured using the interface efm-group <group id> command from the
Global Configuration mode as follows:
>enable
#configure terminal
(config)#interface efm-group 1
(config-efm-group 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
connect on page 2167
loopback detection on page 2168
thresholds xcv on page 2169
xcv-link-removal on page 2170
60000CRG0-35E
S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

EFM Group Command Set

2166