Chapter 3 Ipv6 Ospfv3 Configuration Commands - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches

Chapter 3 IPv6 OSPFv3 Configuration Commands

Note:
At present, the LSQ1GP12EA boards in the S7500E series do not support IPv6.
3.1 OSPFv3 Configuration Commands
3.1.1 abr-summary
Syntax
abr-summary ipv6-address prefix-length [ not-advertise ]
undo abr-summary ipv6-address prefix-length
View
OSPFv3 area view
Parameters
ipv6-address: Destination IPv6 address of the summary route.
prefix-length: Prefix length of the destination IPv6 address, in the range 0 to 128. This
argument specifies the number of consecutive 1s of the prefix, which defines the
network ID.
not-advertise: Specifies not to advertise the summary IPv6 route.
Description
Use the abr-summary command to configure an IPv6 summary route on an area
border router.
Use the undo abr-summary command to remove an IPv6 summary route. Then the
summarized routes are advertised.
By default, no route summarization is available on an ABR.
You can use this command only on an ABR to configure a summary route for the area.
The ABR advertises only the summary route to other areas. Multiple contiguous
networks may be available in an area, where you can summarize them with one route
for advertisement.
Chapter 3 IPv6 OSPFv3 Configuration Commands
3-1