Display Isis Route - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Peer IP Address(es)
Uptime
Adj Protocol

4.1.14 display isis route

Syntax
display isis route [ ipv4 ] [ [ level-1 | level-2 ] | verbose ] * [ process-id ]
View
Any view
Parameters
ipv4: Displays IS-IS IPv4 routing information (the default).
verbose: Displays IS-IS detailed IPv4 routing information.
process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.
level-1: Displays Level-1 IS-IS routes.
level-2: Displays Level-2 IS-IS routes.
Note:
If no level is specified, then both Level-1 and Level-2 (Level-1-2) routing information will
be displayed.
Description
Use the display isis route command to display IS-IS IPv4 routing information.
Examples
# Display IS-IS IPv4 routing information
<Sysname> display isis route 1
Field
Interface IP address of the neighbor
Time that elapsed since the neighbor relationship
was formed.
Adjacency protocol
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv4 Level-1 Forwarding Table
-------------------------------------
4-17
Chapter 4 IS-IS Configuration Commands
Description