Mac-Address (Interface View) - H3C S7500E Series Command Reference Manual

Total Multicast
Table 7-3 display mac-address statistics command output description
Field
MAC TYPE
LEARNED
USER-DEFINED
SYSTEM-DEFINED
IN-USE
AVAILABLE

mac-address (interface view)

Syntax
mac-address { dynamic | static } mac-address vlan vlan-id
undo mac-address { dynamic | static } mac-address vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
dynamic: Dynamic MAC address entries. Aging time is set for these entries.
static: Static MAC address entries. They do not age but you can add or remove them.
mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H
(16-bit hexadecimal digit) can be omitted; for example, inputting "f-e2-1" indicates that the MAC
address is "000f-00e2-0001".
vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the
specified VLAN ID, in the range 1 to 4094.
Description
Use the mac-address command to add or modify a MAC address entry on a specified interface.
Use the undo mac-address command to remove a MAC address entry on the interface.
MAC address type:
Dynamic Unicast
Static Unicast
Total Unicast
Dynamic Multicast
Static Multicast
Total Multicast
Dynamically learned MAC addresses
User defined MAC addresses (dynamic and static)
MAC addresses generated by the system (for example, 802.1x and MAC
authentication)
Number of existing MAC addresses of a specific type
Maximum number of MAC addresses supported by the system
7-6
0 1024
Description