Table of Contents
Advertisement
ppp mp short-sequence
Syntax
ppp mp short-sequence
undo ppp mp short-sequence
View
Interface view
Default level
2: System level
Parameters
None
Description
Use the ppp mp short-sequence command to trigger MP short sequence number header format
negotiation. When the negotiation succeeds, the local end receives packets with short sequence
numbers.
Use the undo ppp mp short-sequence command to restore the default.
By default, the long sequence number header format is used.
This command applies to the incoming direction only. To enable the local end to transmit packets with
short sequence numbers, configure the remote end to receive packets with short sequence numbers.
NOTE:
The sequence number format (long or short) of an MP bundle depends on the configuration of the first
•
channel joining the MP bundle.
To negotiate the use of short sequence numbers on a MP bundle, configure the command on every
•
channel in the MP bundle, because the command will cause PPP re-negotiation.
Examples
# Configure the short sequence number header format of MP on Serial 4/1/9/1:0.
<Sysname> system-view
[Sysname] interface Serial 4/1/9/1:0
[Sysname-Serial4/1/9/1:0] ppp mp Mp-group 4/1/28
[Sysname-Serial4/1/9/1:0] ppp mp short-sequence
reset counters interface mp-group
Syntax
reset counters interface [ mp-group [ interface-number ] ]
View
User view
Default level
2: System level
47
Advertisement
Table of Contents
