Use the undo port connection-mode command to restore the default.
The default connection mode of an interface is normal. However, when you configure an OAA
application, to ensure the normal communication between the switch and the OAP card, you need to
set the connection mode of the interfaces connecting the switch and the card to extended.
This command is supported only on the internal 10GE ports.
Examples
# Set the connection mode of Ten-GigabitEthernet 3/1/1 to extended.
<Sysname> system-view
<Sysname> interface Ten-GigabitEthernet 3/1/1
[Sysname-Ten-GigabitEthernet3/1/1] port connection-mode extend
# Restore the default connection mode of Ten-GigabitEthernet 3/0/1.
[Sysname-Ten-GigabitEthernet3/1/1] undo port connection-mode
port-group manual
Syntax
port-group manual port-group-name
undo port-group manual port-group-name
View
System view
Default Level
2: System level
Parameters
port-group-name: Specifies a port group name, a string of 1 to 32 characters.
Description
Use the port-group manual command to create a port group and enter port group view.
Use the undo port-group manual command to remove a port group.
By default, no port group exists.
Examples
# Create port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1]
reset counters interface
Syntax
reset counters interface [ interface-type [ interface-number ] ]
1-34