Ipv6 Local Pool Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

IPv6 Local Pool Configuration Mode

94
default Set a command to its default(s)
do Run an exec mode command (alias command run)
enable Enable a tunnel parameter
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
profile Assign a profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure a tunnel parameter
host1(config)#dvmrp destination profile global
host1(config-dest-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
enable Enable a tunnel parameter
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
profile Assign a profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure a tunnel parameter
In this mode, you can specify the IPv6 local address pool from which prefixes are allocated
to the requesting router in networks that use DHCPv6. From Global Configuration mode,
type ipv6 local pool poolName and press Enter.
host1(config)#ipv6 local pool dhcpv6pd_pool
host1(config-v6 locall)#?
default Set a command to its default(s)
dns-domain-search Specify a search domain
dns-server Specify the IPv6 DNS server address
do Run an exec mode command (alias command run)
exclude-prefix Specify prefix(es) to be excluded from allocation
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
prefix Specify the IPv6 prefix range
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
NOTE: You must enable the IPv6 local address pool feature to be able to
configure IPv6 local address pools.
Copyright © 2010, Juniper Networks, Inc.