Ipv6 Local Pool Configuration Mode; L2 Transport Load-Balancing-Circuit Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide

IPv6 Local Pool Configuration Mode

In this mode, you can specify the IPv6 local address pool from which prefixes are
allocated to the requesting router in networks that use DHCPv6. From Global
Configuration mode, type ipv6 local pool poolName and press Enter.
host1(config)#ipv6 local pool dhcpv6pd_pool
host1(config-v6 locall)#?
NOTE: You must enable the IPv6 local address pool feature to be able to configure
IPv6 local address pools.

L2 Transport Load-Balancing-Circuit Configuration Mode

In this mode, you can specify a member subinterface for a Martini layer 2 circuit
that is associated with a load-balancing group.
From Global Configuration mode, type mpls l2transport load-balancing-group,
specify a group number and a Martini circuit, and press Enter.
host1(config)#mpls l2transport load-balancing-group 100 mpls-relay 10.1.1.1 30
host1(config-l2transport-load-balancing-circuit)#?
102
Accessing Command Modes
macro Run a CLI macro
no Negate a command or set its default(s)
profile Assign a profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure a tunnel parameter
default Set a command to its default(s)
dns-domain-search Specify a search domain
dns-server Specify the IPv6 DNS server address
do Run an exec mode command (alias command run)
exclude-prefix Specify prefix(es) to be excluded from allocation
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
prefix Specify the IPv6 prefix range
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
member Configure members of a l2transport load-balancing circuit
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration