Parameter Setting - Lenze L-force HighLine C 8400 Series Reference Manual

8.6.1

Parameter setting

Parameterisation dialog in the »Engineer«
Short overview of parameters for "Referencing" operating mode:
Parameter
C01221
C01224/1
C01225/1
C01224/2
C01225/2
C01226/1
C01222
C01223
C01227/1
C01227/2
C01228
C01229/1
C01229/2
C01246/1
C01246/2
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Info
MCK: Ref. mode
MCK: Ref. initial speed
MCK: Ref. initial acceleration
MCK: Ref. search speed
MCK: Ref. search acceleration
MCK: Ref. S-ramp time
MCK: Ref. M limit mode 14/15
MCK: Ref. waiting time mode 14/15
MCK: Ref. offset reference degree
MCK: Ref. home position
MCK: Ref. sequence profile
MCK: Positive SW limit position
MCK: Negative SW limit position
MCK: Ref. TP signal source (from version 06.00.00)
MCK: Set.Ref. signal source (from version 06.00.00)
L
8400 HighLine C | Reference manual
Basic drive functions (MCK)
Homing
Lenze setting
Value Unit
12: >_Lp
720.0000 unit/s
720.0000 unit/s2
180.0000 unit/s
720.0000 unit/s2
0.000 s
10.00 %
100 ms
0.0000 unit
0.0000 unit
0
0.0000 units
0.0000 units
0: No TP
0: No TP
495