Error Messages Of The Operating System - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Diagnostics & error management

Error messages of the operating system

9.9 Error messages of the operating system
This chapter describes all error messages of the controller operating system and possible
causes & remedies.

Tip!
Each error message is also saved to the logbook in chronological order.
( 568)
9.9.1 Structure of the 32-bit error number (bit coding)
If an error occurs in the controller, the internal fault memory saves a 32-bit value which
contains the following information:
0
30
Bit 31 29
[9-3] Structure of the error number
 Display parameter:
 The 32-bit error number is output by the SB
wStateDetermFailNoLow (Low-Word) and wStateDetermFailNoHigh (high word).
– From version 06.00.00 onwards:
C00148
number at the wStateDetermFailNoLow output and the value "0" at the
wStateDetermFailNoHigh output (see the following chapter).
 For the sake of legibility, the error number in the logbook and in
with the following syntax:
[Error type].[Error subject area no.].[Error ID]
580
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
1 2
26 25 16 15
C00168
(bit 15 = "1"), the SB LS_DriveInterface
L
3
LS_DriveInterface
If the "Use 16BitFailNo." option is activated in
provides the short 16-bit error
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Logbook
 Reserved
 Error type
0
 Error subject area
 Error ID
to the outputs
C00165 is displayed