Lenze L-force HighLine C 8400 Series Reference Manual page 941

C01218
Parameter | Name:
C01218 | PosFollower: Setting
Settings for "Position follower" mode
Setting range
(min. hex value | max. hex value)
0x00
Value is bit-coded: (
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Read access
C01219
Parameter | Name:
C01219 | MCK: Speed follower setting
Settings for "Speed follower" mode
Setting range
(min. hex value | max. hex value)
0x00
Value is bit-coded: (
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Read access
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
= bit set)
Speed FF control.: nSpeedSetValue_a "1" ≡ speed feedforward control value comes from main
Speed FF control: nSpeedAddValue_v "1" ≡ speed feedforward control value comes from
HW limit switch on
SW limit switch on
Reserved
Reserved
Reserved
Reserved
Write access CINH PLC STOP
= bit set)
Reserved
Reserved
HW limit switch on
SW limit switch on
Reserved
Reserved
Reserved
Position controller off
Write access CINH PLC STOP
L
8400 HighLine C | Reference manual
Lenze setting
0xFF 0x0C (decimal: 12)
Info
setpoint nSpeedSetValue_a
additive speed value nSpeedAddValue_v
"1" ≡ Travel range monitoring via hardware limit switch
is active. The error response can be parameterised in
C00595/1 and C00595/2.
"1" ≡ Travel range monitoring via parameterised
software limit positions is active. The error response can
be parameterised in
No transfer COM MOT
Lenze setting
0xFF 0x0C (decimal: 12)
Info
"1" ≡ Travel range monitoring via hardware limit switch
is active. The error response can be parameterised in
C00595/1 and C00595/2.
"1" ≡ Travel range monitoring via parameterised
software limit positions is active. The error response can
be parameterised in
"1" ≡ Position controller is deactivated. Thus, the
compensation of the following error is switched off.
No transfer COM MOT
Parameter reference
Parameter list | C01218
Data type: UNSIGNED_8
Index: 23357 = 5B3D
d
Position follower
C00595/3 and C00595/4.
Data type: UNSIGNED_8
Index: 23356 = 5B3C
d
Speed follower
C00595/3 and C00595/4.
h
h
941