Parameter Setting - Lenze L-force HighLine C 8400 Series Reference Manual

6.4.1

Parameter setting

Proceed as follows to open the parameterisation dialog for setting a TP signal source:
1. Go to the Terminal Assignment tab and select "Digital input terminals TouchProbe" in
the Control connections list field:
2. Click the

Tip!
If the "Table positioning" technology application is used, the following
parameterisation dialog can be opened for the selected TP source in the
parameterisation dialogs for the
the Set up touch probe... button:
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
button for the digital input that is to be set for the touch probe detection.
Profile entry
L
8400 HighLine C | Reference manual
Touch probe detection
and the basic "Homing" function via
I/O terminals
345