Communication Time - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
System bus "CAN on board"
General information
10.1.3

Communication time

The communication time is the time between the start of a request and the arrival of the
corresponding response.

Tip!
The communication times in the CAN network depend on:
• the processing time in the device
• the telegram runtime (baud rate/telegram length)
• the bus load (especially if the bus is charged with PDOs and SDOs at a low baud
rate)
Processing time in the 8400 controller
No dependencies exist between parameter data and process data.
 Parameter data: approx. 5 ms (typical value)
– For parameters concerning the motor control (e.g. C00011), the processing time may
be longer (up to 30 ms).
 Process data: 1 ms
616
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
L
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011