User Menu For Quick Access To Frequently Used Parameters - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Introduction: Parameterising the controller
General notes on parameters
2.3.4

User menu for quick access to frequently used parameters

When a system is installed, parameters must be changed time and again until the system
runs satisfactorily. The user menu of a device contains a selection of frequently used
parameters to be able to access and change these parameters quickly.
Parameter
C00051
C00053
C00054
C00061
C00137
C00166/3
C00011
C00039/1
C00039/2
C00012
C00013
C00015
C00016
C00022
C00120
C00087
C00099
C00200
C00105
C00173
Highlighted in grey = display parameter

Tip!
The user menu can be freely configured in C00517.
In the »Engineer«, you can configure the user menu comfortably via the User menu
tab (see »Engineer« online help).
The
menu. Then, all other parameters cannot be accessed without knowing the
password and are thus protected against unwanted changes.
46
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Name
MCTRL: Actual speed value
DC-bus voltage
Motor current
Heatsink temperature
Device status
Mess. - status det. error
Appl.: Reference speed
Fixed setpoint 1
Fixed setpoint 2
Acceleration time - main setpoint
Deceleration time - main setpoint
VFC: V/f base frequency
VFC: Vmin boost
Imax in motor mode
Setting of motor overload (I
Rated motor speed
Firmware version
Firmware product type
Decel. time - quick stop
Mains voltage
password protection serves to restrict the access to parameters of the user
L
Lenze setting
-
-
-
-
-
-
1500 rpm
40.00 %
60.00 %
2.000 s
2.000 s
50 Hz
1.60 %
depending on the device power
2
xt) 100.00 %
1460 rpm
-
-
2.000 s
0: "3ph 400V / 1ph 230V"
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011