Lenze L-force HighLine C 8400 Series Reference Manual page 395

Identifier
nAccOverride_a
bHomeStartStop
bHomeSetPosition
bHomeResetPosition
bHomeMark
bPosSetProfilePosition
bPosSetActualPosition
bPosExecute
bPosFinishTarget
bPosDisableFollowProfile
bPosStop
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Information/possible settings
Data type
Value for Acceleration override
• Percentage multiplier for the currently active acceleration.
INT
• 16384 ≡ 100 % of the parameterised acceleration of the corresponding operating
mode.
• Values > 16384 are ignored.
• If the override value is 0 %, acceleration ceases.
Homing: Start/stop homing
BOOL
TRUE Start homing
TRUE FALSE Stop homing
Homing: Set home position
BOOL
TRUE Set home position
Homing: Reset home position
BOOL
TRUE Reset the "Reference known" status
Homing: Input for reference switch (pre-switch off mark)
• This input responds to the FALSE status (fail-safe) and is to be connected to the
BOOL
corresponding digital input to which the reference switch is connected.
Position teaching: MCK setpoint position
BOOL
TRUE Teach MCK setpoint position into the selected profile.
Position teaching: Current position
BOOL
TRUE Teach current position into the selected profile.
Positioning: Start travelling
BOOL
FALSE TRUE Execute selected profile
Positioning: Complete cancelled profile
BOOL
FALSE TRUE A positioning process previously cancelled, e.g. by bPosStop or due to
a device error, is resumed by travelling to the original target.
Positioning: Do not execute sequence profile (switch-off profile linkage)
BOOL
TRUE Evaluation of the sequence profile number parameterised in
C01307/1...15
Positioning: Cancel travelling
BOOL
TRUE Stop positioning
From version
("PosExecute" will be blocked).
L
8400 HighLine C | Reference manual
Technology applications
for the selected profile is suppressed.
11.00.00, more travel requests will be inhibited
TA "Table positioning"
395