Led Status Displays For The System Bus - Lenze L-force HighLine C 8400 Series Reference Manual

10.3

LED status displays for the system bus

CAN-RUN
Frequency of the display
Permanently red
Flashes
Green is blinking every 0.2 s
Green is blinking every 0.2 s
Red is blinking once, 1 s off
Green is blinking every 0.2 s
Red is blinking twice, 1 s off
Permanently green
Permanently green
Red is blinking once, 1 s off
Permanently green
Red is blinking twice, 1 s off
Permanently green
Red is blinking 3 times, 1 s off
Green is blinking every second
Green is blinking every second
Red is blinking once, 1 s off
Green is blinking every second
Red is blinking twice, 1 s off
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
 CAN-RUN:
Signals the CANopen state
CAN-ERROR
 CAN-ERROR:
Signals a CANopen error
CAN signalling and meaning
CAN-Run: -, CAN-Error: Bus Off
Automatic detection of baud rate is active
CAN-Run: Pre-Operational, CAN-Error: -
CAN-Run: Pre-Operational, CAN-Error: Warning Limit reached
CAN-Run: Pre-Operational, CAN-Error: Node Guard Event
CAN-Run: Operational, CAN-Error: -
CAN-Run: Operational, Fault: Warning Limit reached
CAN-Run: Operational, CAN-Error: Node Guard Event
CAN-Run: Operational, CAN-Error: Sync Message Error
CAN-Run: Stopped, CAN-Error: -
CAN-Run: Stopped, CAN-Error: Warning Limit reached
CAN-Run: Stopped, CAN-Error: Node Guard Event
L
System bus "CAN on board"
LED status displays for the system bus
619