Parameterising The Application - Lenze L-force HighLine C 8400 Series Reference Manual

3.6.4

Parameterising the application

The application parameters can be found on the right side of the Application parameter
tab:
1. In the
wiring of the terminals.
– The corresponding wiring diagram is displayed in a pop-up window if you click the
button right to the list field.
– For a detailed description, see the chapter
modes".
2. Optional: Use a process controller.
– For this purpose, select the desired operating mode in the
mode (C00242) list field.
– For a detailed description see the
– Go to the parameterisation dialog of the process controller via the Process controller
button.
3. Optional: Use a motor potentiometer.
– For this purpose, select "1: On" in the
– For a detailed description see the
– Go to the parameterisation dialog of the motor potentiometer via the Motor
potentiometer button.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Commissioning of the "Actuating drive speed" technology application
Control mode list field (C00007), select the control mode suitable for the
( 371)
L
8400 HighLine C | Reference manual
"Terminal assignment of the control
L_PCTRL_1 function block.
L_MPot_1: Use (C00806) list field.
L_MPot_1 function block.
Commissioning
L_PCTRL_1: Operating
( 1288)
( 1220)
63