Basic Settings - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Motor control (MCTRL)
Sensorless vector control (SLVC)
5.7.3

Basic settings

The following "Initial commissioning steps" must be performed to commission the
sensorless vector control:
Initial commissioning steps
1. Determine the motor control:
C00006
2. Set the motor selection/motor data
• When selecting and parameterising the motor, the motor nameplate data and the equivalent circuit
diagram data are relevant. Detailed information can be found in the
( 132)
Depending on the motor manufacturer, proceed as follows:
Lenze motor:
Selecting a motor from the motor catalogue in the
»Engineer«
- or -
1. Set the motor nameplate data
2. Automatic motor data identification
3. Define the type of control:
bTorquemodeOn = FALSE:
bTorquemodeOn = TRUE:
4. Set the slip compensation (C00021).

Tip!
Information on the optimisation of the control mode and the adaptation to the
real application is provided in the
We recommend to use the flying restart function for connecting/synchronising the
inverter to an already rotating drive system.
Parameterisable additional functions are described correspondingly in the chapter
"Parameterisable additional
190
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
= "4: SLVC: Vector control"
" chapter.
Speed control with torque limitation
Torque control with speed limitation
Slip compensation ( 258)
functions".
L
"Motor selection/Motor
Third party manufacturer's motor:
1. Set the motor nameplate data
2. Automatic motor data identification
equivalent circuit diagram data manually:
C00082: Motor rotor resistance
C00084: Motor stator resistance
C00085: Motor stator leakage inductance
C00092: Motor magnetising inductance
C00095: Motor magnetising current
"Optimising the control
Flying restart function
( 243)
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
data".
or set known
mode" chapter.
( 191)
( 250)