Lenze L-force HighLine C 8400 Series Reference Manual page 740

8400 HighLine C | Reference manual
Parameter reference
Parameter list | C00144
C00144
Parameter | Name:
C00144 | Switching freq. reduct. (Temp.)
Activation of the automatic switching frequency reduction if the temperature is too high
Selection list
(Lenze setting printed in bold)
Read access
C00148
Parameter | Name:
C00148 | LS_DriveInterface: Error message config.
From version 04.00.00
Selection of the device statuses for which the bCollectedFail group error output of SB
to TRUE.
Setting range
(min. hex value | max. hex value)
0x0000
Value is bit-coded: (
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Bit 14
Bit 15
Read access
740
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
0 Off
1 On
Write access CINH PLC STOP
= bit set)
SafeTorqueOff
ReadyToSwitchOn
SwitchedOn
TroubleQSP
Trouble
Fault
Warning
ImpIsActive
CInhIsActive
Fail CAN_Management
Reserved
Reserved
Reserved
Reserved
Lock bFail at TroubleQSP
Use 16BitFailNo.
Write access CINH PLC STOP
L
Info
Automatic switching frequency reduction deactivated
Automatic switching frequency reduction activated
No transfer COM MOT Scaling factor: 1
Lenze setting
0xFFFF 0x0030 (decimal: 48)
Info
From version 06.00.00
From version 11.00.00
If this bit is set, the bFail output of the
SB LS_DriveInterface
status.
• Advantage: Even in the "TroubleQSP" status, an error
occurred before can still be recognised.
From version 06.00.00
If this bit is set, the short 16-bit error number
(wStateDetermFailNoShort) is also provided at the
wStateDetermFailNoLow output of the
SB LS_DriveInterface.
• In this case, the wStateDetermFailNoHigh output is
"0".
• Advantage: The bus transfer of the error numbers is
possible via a data word without changing the
interconnection of the technology application.
No transfer COM MOT
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Data type: UNSIGNED_8
Index: 24431 = 5F6F
d
Data type: UNSIGNED_16
Index: 24427 = 5F6B
d
LS_DriveInterface is to be set
is also set in the "TroubleQSP"
h
h