Saving Parameter Settings Safe Against Mains Failure; Enable Controller And Test; Application - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Commissioning
Commissioning of the "Table positioning" technology application
More detailed information on the technology application:
TA "Table positioning"
Basic signal flow
Internal interfaces | Application block "LA_TabPos"
Process data assignment for fieldbus communication
Terminal assignment of the control modes
Setting parameters (short overview)
Configuration parameters
3.7.5

Saving parameter settings safe against mains failure

The parameter set must be saved to the device safe against mains failure to prevent
parameter settings becoming lost due to mains switching.
Save parameter set.

3.7.6 Enable controller and test application

Stop!
Before stipulating a speed setpoint, check whether the brake in the form of a
holding brake on the motor shaft has been released!

Note!
If the controller is enabled and the "Inhibit at power-on" auto-start option is
activated in
remains in the "ReadyToSwitchOn" state.
To be able to change to the "SwitchedOn" status, the controller enable must be
deactivated first: set terminal X5/RFR to LOW level.
If the controller is in the "SwitchedOn" state:
1. Enable controller: Set terminal X5/RFR to HIGH level or close contact.
– If there is no other active source for controller inhibit, the controller changes from
the "SwitchedOn" state to the "OperationEnabled" state.
– The Diagnostics tab and
2. Select the respective control signals via the digital inputs (see sections below).
80
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
( 387)
( 388)
( 413)
( 413)
C00142 (Lenze setting) when the mains is connected, the controller
C00158 display all active sources for the controller inhibit.
L
( 391)
( 411)
( 401)
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011