Lenze L-force HighLine C 8400 Series Reference Manual page 649

Meaning of the error codes
The error codes are standardised acc. to DS301, V4.02.
Error code
0x0503 0000
0x0504 0000
0x0504 0001
0x0504 0002
0x0504 0003
0x0504 0004
0x0504 0005
0x0601 0000
0x0601 0001
0x0601 0002
0x0602 0000
0x0604 0041
0x0604 0042
0x0604 0043
0x0604 0047
0x0606 0000
0x0607 0010
0x0607 0012
0x0607 0013
0x0609 0011
0x0609 0030
0x0609 0031
0x0609 0032
0x0609 0036
0x0800 0000
0x0800 0020
0x0800 0021
0x0800 0022
0x0800 0023
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Explanation
Toggle bit not changed
SDO protocol expired
Invalid or unknown client/server command specifier
Invalid block size (only block mode)
Invalid sequence number (only block mode)
CRC error (only block mode)
Not sufficient memory
Object access not supported
Attempt to read a write-only object
Attempt to write to a read-only object
Object not listed in object directory
Object not mapped to PDO
Number and length of the objects to be transferred exceed the PDP length.
General parameter incompatibility
General internal device incompatibility
Access denied because of hardware error
Unsuitable data type, unsuitable service parameter length
Unsuitable data type, service parameter length exceeded
Unsuitable data type, service parameter length not long enough
Subindex does not exist
Parameter value range exceeded
Parameter values too high
Parameter values too low
Maximum value falls below minimum value
General error
Data cannot be transferred/saved for application.
Data cannot be transferred/saved for application due to local control.
Data cannot be transferred/saved for application due to current device status.
Dynamic generation of object directory failed or no object directory available (e.g. object
directory generated from file, generation not possible because of a file error).
L
8400 HighLine C | Reference manual
System bus "CAN on board"
Parameter data transfer
649