Lenze L-force HighLine C 8400 Series Reference Manual page 41
Inverter drives
Hide thumbs
Also See for L-force HighLine C 8400 Series:
- Mounting instructions (16 pages) ,
- Reference manual (1602 pages)
Table of Contents
Advertisement
LCD display
Function - left function key
Change parameter setting
(change to editing mode)
Back to main menu
Parameter can only be changed when the controller is inhibited.
Save all parameter settings in the memory module safe against mains failure
Control elements
Execute the function assigned to the function key (see LCD display)
Execute the stop function set in
Deactivate stop function again (Lenze setting: Enable controller again)
In the menu level: Select menu/submenu
In the parameter level: Select parameter
In the editing mode: Change marked digits or select list entry
In the menu level: Select submenu/change to parameter level
In the editing mode: Cursor to the right
In the menu level: One menu level higher (if available)
In the parameter level: Back to menu level
In the editing mode: Cursor to the left
Menu structure
In the keypad, the parameters are classified into various menus and submenus.
The USER menu includes a selection of frequently used parameters.
The Code list contains all parameters.
The Go to param function enables you to reach the corresponding parameter directly.
The Logbook logs all errors and their chronological history.
The Diagnostics menu contains diagnostic/display parameters for displaying device-
internal process factors, current actual values and status messages.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
Introduction: Parameterising the controller
Function - right function key
Accept change in the controller
(no saving with mains failure protection )
Abort (discard change)
C00469
(Lenze setting: Inhibit controller)
L
General notes on parameters
41
Hide quick links:
Advertisement
Table of Contents
