Monitoring - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Motor control (MCTRL)

Monitoring

5.14 Monitoring
Many monitoring functions that are integrated into the controller can detect errors and
thus protect the device/motor from damage or overload.
 Detailed information on the individual monitoring functions can be found in the
following subchapters.
Monitoring
Device overload monitoring (Ixt)
Motor load monitoring (I2xt)
Motor temperature monitoring (PTC)
Brake resistor monitoring (I2xt)
Motor phase failure monitoring
Motor phse error monitoring before
operation
Mains phase failure monitoring
Maximum current monitoring
Maximum torque monitoring
Motor speed monitoring
Encoder open-circuit monitoring
Parameterisable responses
If a monitoring function trips, the response set via the corresponding parameter is carried
out. The following responses can be selected:
 "No response": Response/monitoring is deactivated.
 "Fault": Change of the operating status by a pulse inhibit of the power output stage.
 "Warning": Operating status of the controller remains unchanged. Only a message is
entered into the logbook of the controller.
Related topics:
Device state machine and device statuses
Diagnostics & error management
Basics on error handling in the controller
Error messages of the operating system
288
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Response
Lenze setting
Warning
Warning
Fault
No Reaction
No Reaction
Warning
No Reaction
No Reaction
Fault
Fault
( 111)
( 559)
( 559)
( 580)
L
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Error message
(with activated
Configuration
monitoring)
C00604 OC5
C00606 OC6
C00585 OH3
C00574 OC12
C00597 LP1
C02844/2
C00565 Su02
C00609 OC7
C00608 OT1
- OS2
C00586 SD3