8400 HighLine C | Reference manual
Commissioning
Commissioning of the "Table positioning" technology application
Commissioning steps
Below find a description of the commissioning steps of the "Table positioning" application
shown in illustration [3-2].
Please observe the sequence of the steps in the following chapters and follow them
through carefully. This will help you to commission your controller quickly and as safely as
possible:
Prepare controller for commissioning
Creating an »Engineer« project and going online
Parameterising the motor control
Parameterising the application
Saving parameter settings safe against mains failure
Enable controller and test application
68
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
( 69)
( 70)
( 71)
( 72)
( 80)
( 80)
L
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011