Lenze L-force HighLine C 8400 Series Reference Manual page 837

Parameter | Name:
C00701 | LA_NCtrl: Digital connection list
C00701/45
C00701/46
C00701/47
C00701/48
Read access
C00705
Parameter | Name:
C00705 | LA_NCtrl_Out: Analog signal list
This code is for device-internal use only and must not be written to by the user!
C00706
Parameter | Name:
C00706 | LA_NCtrl_Out digital signal list
This code is for device-internal use only and must not be written to by the user!
C00710
Parameter | Name:
C00710 | LA_TabPos: Analog connection list
Connection parameters for "Table positioning" application: 16-bit inputs
• Selection of the 16 bit output signals to be connected to the 16 bit input signals
• The selection list contains all 16 bit output signals which can be assigned to the 16 bit inputs displayed by the
subcodes.
Selection list
See selection list - analog signals
Subcodes
C00710/1
C00710/2
C00710/3
C00710/4
C00710/5
C00710/6
C00710/7
C00710/8
C00710/9
C00710/10
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
0: Not connected
0: Not connected
0: Not connected
0: Not connected
Write access CINH PLC STOP
Lenze setting
0: Not connected
0: Not connected
0: Not connected
0: Not connected
0: Not connected
0: Not connected
0: Not connected
0: Not connected
0: Not connected
0: Not connected
L
8400 HighLine C | Reference manual
LA_NCtrl: bFreeIn5
(input for binary user signal 5)
LA_NCtrl: bFreeIn6
(input for binary user signal 6)
LA_NCtrl: bFreeIn7
(input for binary user signal 7)
LA_NCtrl: bFreeIn8
(input for binary user signal 8)
No transfer COM MOT Scaling factor: 1
Info
LA_TabPos: wCanDriveControl
(input for control word from CAN to device control)
LA_TabPos: wMciDriveControl
(input for control word from communication interface to
device control)
LA_TabPos: nTorqueMotLim_a
(input for maximum torque in motor mode)
LA_TabPos: nTorqueGenLim_a
(input for maximum torque in generator mode)
LA_TabPos: nMainSetValue_a
(input for main speed setpoint)
LA_TabPos: nAuxSetValue_a
(input for additional speed setpoint)
LA_TabPos: wMckCtrl1
(input for MCK control word 1)
LA_TabPos: wMckCtrl2
(input for MCK control word 2)
LA_TabPos: wMckOperationMode
(input for selection of MCK operating mode)
LA_TabPos: wPosProfileMode
(input for selection of MCK positioning mode in
positioning mode)
Parameter reference
Parameter list | C00705
Data type: UNSIGNED_16
Index: 23874 = 5D42
d h
Data type: UNSIGNED_16
Index: 23870 = 5D3E
d h
Data type: UNSIGNED_16
Index: 23869 = 5D3D
d h
Data type: UNSIGNED_16
Index: 23865 = 5D39
d h
837