Defining Current And Speed Limits - Lenze L-force HighLine C 8400 Series Reference Manual

5.3

Defining current and speed limits

Limitation of the speed setpoint
Parameterising the reference speed in
speed if a speed setpoint of 100% is specified.
All speed setpoint selections are provided in % and always refer to the reference speed set
in C00011.

Tip!
For reasons of achievable resolution and the accuracy involved, the reference
speed should be geared to the speed range required for the respective application.
Lenze recommendation: Reference speed (C00011) = 1500 ... 3000 rpm
Irrespective of the selected motor control, there are more limitation options:
Parameter
C00909/1
C00909/2
C00910/1
C00910/2

Note!
In the torque-controlled operation (bTorquemodeOn = TRUE), the limitation of
the speed setpoint does not have any effect! In this case, a permissible speed
range can be defined via speed limitation (nSpeedHighLimit and
nSpeedLowLimit).
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
C00011
Info
Max. positive speed
Max. negative speed
Max. positive output frequency
Max. negative output frequency
L
8400 HighLine C | Reference manual
Motor control (MCTRL)
Defining current and speed limits
means that the drive must rotate at the set
Lenze setting
Value Unit
120 %
120 %
1000 Hz
1000 Hz
147