Parameterising The Application - Lenze L-force HighLine C 8400 Series Reference Manual

3.8.4

Parameterising the application

The application parameters can be found on the right side of the Application parameter
tab:
1. In the
(if you have not already done so while creating the project).
– After the "Switch-off positioning" application is selected, the contents of the tab
change, e.g. the Process controller and Motor potentiometer buttons are not shown
any more.
2. In the
switch-off positioning without pre-switch off the
selected.
– The corresponding wiring diagram is displayed in a pop-up window if you click the
button right to the list field.
– For a detailed description, see the chapter
modes".
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Commissioning of the "Switch-off positioning" technology application
Application list field (C00005), select the "Switch-off positioning" application
Control mode list field (C00007) and in case of illustration [3-3], for the shown
( 371)
L
8400 HighLine C | Reference manual
"Terminals 2" control mode must be
"Terminal assignment of the control
Commissioning
87