Feed Constant - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Basic drive functions (MCK)
Basic settings
8.4.1.2

Feed constant

The feed constant corresponds to the machine movement for one revolution of the
gearbox output shaft.
 The entry in the Feed constant (C01204) field is made in the user unit [units] in respect
of the revolution.
 In the case of a conveyor drive, the feed constant is obtained from the drive roll's
circumference, which, in the following example, is calculated on the basis of the
indicated diameter:
d = diameter
Feed constant
[8-8] Schematic diagram: Feed constant for a conveyor driver
 In the case of a spindle drive (linear axis), the feed constant is derived from the
leadscrew pitch. The feed constant indicates the distance the slide travels during one
revolution of the spindle (in the following example: 5.023 mm).
h = leadscrew pitch (to be obtained from the technical data of the linear axis)
[8-9] Schematic diagram: Feed constant for a spindle drive
 In the case of a rotary table and its specification as an angle, the feed constant
is = 360°/revolution.
478
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
M
d = 200 mm
[unit]
π d ⋅ π 200 ⋅
--------------------------- -
= =
Revolution
M
h = 5.023 mm
L
mm
628.3185
--------------------------- - --------------------------- -
=
Revolution Revolution
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
mm