Stop - Lenze L-force HighLine C 8400 Series Reference Manual

8400 HighLine C | Reference manual
Basic drive functions (MCK)

Stop

8.9 Stop
If the "normal stop" operating mode is active, the drive is brought to a standstill with a
parameterisable deceleration ramp.
8.9.1 Parameter setting
Short overview of parameters for "Normal stop" operating mode:
Parameter
C01251/1
C01252/1
8.9.2 Requesting the operating mode
Request for "Normal stop" operating mode by means of the
MCK control word
Bit 31
X
X = Status not significant
If the MCKInterface is connected upstream to the Motion Control Kernel and if the
operating mode is requested at the
bOperationMode_1...8 process inputs are available.
534
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Info
Normal stop: Deceleration
Stop: S-ramp time
... Bit 4
... X
L_MckCtrlInterface
L
Lenze setting
720.0000 units/s2
MCK control
Bit 3 Bit 2
OpMode_Bit3 OpMode_Bit2 OpMode_Bit1
0 1
FB, the wOperationMode and
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Value Unit
0.000 s
word:
Bit 1 Bit 0
OpMode_Bit0
0 0