Lenze L-force HighLine C 8400 Series Reference Manual page 480

8400 HighLine C | Reference manual
Basic drive functions (MCK)
Basic settings
Blocking zone for "absolute (Cw)" and "absolute (Ccw)"positioning modes
Set a blocking zone in
modes in which no target positions are approached. This blocking zone around the current
setpoint position serves to consider drift motions of the shaft in case of controller
inhibit/enable cycles in order to prevent e.g. an unwanted motion by one cycle.

Stop!
Target positions in the set blocking zone are always approached with the
shortest possible distance in the "absolute (Cw)" and "absolute (Ccw)"
positioning modes!
If the blocking zone is too large, the drive may travel to the opposite direction!
[8-11] Definition of the blocking zone
Display of the target position in the "Positioning" mode
Positioning mode
Absolute (shortest path)
absolute (Cw)
absolute (Ccw)
Continuous
Relative
480
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
C01245/2 for the "absolute (Cw)" and "absolute (Ccw)" positioning
 Target positions outside the blocking zone are
approached with the selected positioning mode.
 The blocking zone is limited internally to half the
cycle.
Target position displayed in C01210/6 in [units]
Defined position
Defined position
Defined position
214748.3647
Modulo position + defined position
L
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011