Lenze L-force HighLine C 8400 Series Reference Manual page 346

8400 HighLine C | Reference manual
I/O terminals
Touch probe detection
Short overview of the relevant parameters:
Parameter
C02810/3...7
C02811/3...7
C02812/3...7
C02813/1...3
C02814/1...3
C02815/3...7
C02816/3...7
Highlighted in grey = display parameter
Edge selection
Select which edge the corresponding input is to respond to.
 In the case of signal sources DI3 ... DI5, the edge sensitivity can also be dynamically
changed via inputs at the
Sensor delay
This setting serves to compensate for a sensor delay of the touch probe sensor, if any.
 Typical values for laser photoelectric barriers are e.g. 300 μs.
 Delay of the digital inputs for the 8400 device series:
– 5 μs for a rising edge
– 25 μs for a falling edge
 Internal automatic compensation for device-internal signal delay due to encoder zero
pulse.
Pos Offset
Use this setting to add an offset to the position value measured by touch probe. This may
be required if the touch probe sensor has assumed a disadvantageous position on the
machine. By adding an offset the touch probe sensor can be moved to a position which is
more convenient to the application.
346
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Info
TPDigIn3 ... TPDigIn7: Edge selection
TPDigIn3 ... TPDigIn7: Sensor delay
TPDigIn3 ... TPDigIn7: Pos Offset
TPDigIn3 ... TPDigIn5: Window start
TPDigIn3 ... TPDigIn5: Window end
TPDigIn3 ... TPDigIn7: Position source
TPDigIn3 ... TPDigIn7: Signal counter
LS_TouchProbe
L
Lenze setting
0.0000 units
0.0000 units
0.0000 units
0: Position encoder actual value
SB.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Value Unit
0: Off
0 μs
-