Lenze L-force HighLine C 8400 Series Reference Manual page 103

Short overview of device commands
Device commands described in this chapter:
C00002
Subcode:
1
6
11
16
17
19
21
27
Device commands described in other chapters:
C00002
Subcode:
23 Motor parameter identification
26 CAN reset node
28 Check MasterPin
29 Set binding ID
30 Delete binding ID
31 Set password
32 Check password
33 Delete password
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Device command
Load Lenze setting
Load all parameter sets
Save all parameter sets
Enable/Inhibit controller
Activate/Deactivate quick stop
Reset error
Delete logbook
Device search function
(from version 06.00.00)
Device command
Automatic motor data identification
Reinitialising the CANopen system bus interface
(from version 06.00.00)
Unlocking the controller with a MasterPin
(from version 06.00.00)
Device personalisation
(from version 06.00.00)
Device personalisation
(from version 06.00.00)
Password protection
(from version 06.00.00)
Password protection
(from version 06.00.00)
Password protection
L
8400 HighLine C | Reference manual
Device control (DCTRL)
Device commands (C00002/x)
Controller
inhibit
required
Controller
inhibit
required
Status information
dynamic
dynamic
dynamic
static
static
static
static
static
Status information
dynamic
static
static
static
static
static
static
static
103