Changing The Terminal Assignment With The Keypad - Lenze L-force HighLine C 8400 Series Reference Manual

6.6.2

Changing the terminal assignment with the keypad

You can reconfigure the preconfigured terminal assignment with the keypad (and with the
»Engineer«) by means of so-called configuration parameters.
 Each configuration parameter represents a signal input of a system block or application
block.
 Each configuration parameter contains a selection list with output signals of the same
type of data.
 Logical linking is thus carried out by selecting the output signal for the corresponding
signal input.
In the following example, digital output 1 (LS_DigitalOutput.bOut1 input) is logically
linked to the status signal "Drive ready" (LA_nCtrl_bDriveReady output signal):
Configuration parameters for the analog and digital output terminals
The preconfigured assignment of the analog and digital output terminals can be altered by
means of the subcodes of
Parameter
Analog outputs - terminal assignment
C00620/1
C00620/39
C00620/38
C00620/40
Digital outputs - terminal assignment
C00621/1
C00621/2
C00621/99
C00621/100
C00621/101
Other subcodes (not shown here) allow the configuration of input signals of different
system blocks and port blocks.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
C00620 and C00621:
Info
LS_AnalogOutput: nOut1_a (V)
LS_AnalogOutput: nOut1_a (I)
LS_AnalogOutput: nOut2_a (V)
LS_AnalogOutput: nOut2_a (I)
LS_DigitalOutput:bRelay
LS_DigitalOutput:bOut1
LS_DigitalOutput: bOut2
LS_DigitalOutput: bOut3
LS_DigitalOutput: bOut HighCurrent
L
8400 HighLine C | Reference manual
User-defined terminal assignment
1003: LA_nCtrl_nMotorSpeedAct_a
0: Not connected
0: Not connected
0: Not connected
1001: LA_nCtrl_bDriveFail
1000: LA_nCtrl_bDriveReady
0: Not connected
0: Not connected
0: Not connected
I/O terminals
Lenze setting
Value Unit
353