Lenze L-force HighLine C 8400 Series Reference Manual page 773

C00351
Parameter | Name:
C00351 | CAN baud rate
Setting of the baud rate via parameters
• The baud rate can only be parameterised if the baud rate "0" is set via the DIP switches.
• A change in the baud rate will not be effective until a CAN Reset Node is performed.
Selection list
(Lenze setting printed in bold)
Read access
C00352
Parameter | Name:
C00352 | CAN slave/master
The drive starts as CAN master after mains switching if a value of "1" has been entered and saved here.
Selection list
(Lenze setting printed in bold)
Read access
C00353
Parameter | Name:
C00353 | CAN IN/OUT COBID source
Identifier assignment procedure for the CANx In/Out process data
Selection list
Subcodes
C00353/1
C00353/2
C00353/3
Read access
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
0 500 kbps
1 250 kbps
2 125 kbps
3 50 kbps
4 1000 kbps
5 20 kbps
Write access CINH PLC STOP
0 Slave
1 Master
Write access CINH PLC STOP
0 COBID = C0350 + LenzeBaseID
1 COBID = C0350 + CANBaseID
2 COBID = C0354/x
Lenze setting
1: COBID = C0350 + CANBaseID
1: COBID = C0350 + CANBaseID
1: COBID = C0350 + CANBaseID
Write access CINH PLC STOP
L
8400 HighLine C | Reference manual
No transfer COM MOT Scaling factor: 1
No transfer COM MOT Scaling factor: 1
Info
COBID = device address + LenzeBaseID
COBID = device address + CANBaseID (C00354/x)
COBID = direct setting from
Info
COBID source CAN1_IN/OUT
COBID source CAN2_IN/OUT
COBID source CAN3_IN/OUT
No transfer COM MOT Scaling factor: 1
Parameter reference
Parameter list | C00351
Data type: UNSIGNED_8
Index: 24224 = 5EA0
d h
System bus "CAN on board"
Data type: UNSIGNED_8
Index: 24223 = 5E9F
d h
System bus "CAN on board"
Data type: UNSIGNED_8
Index: 24222 = 5E9E
d h
System bus "CAN on board"
C00354/x
773