Lenze L-force HighLine C 8400 Series Reference Manual page 525

Symbol Profile parameter
Final speed (C01305/1...15)
F
This specifies the speed at which the drive is to start the next profile after reaching the target position.
With a final speed not equal to "0", "velocity changeover" or "overchange" is possible, i.e. when the
target position is reached, a second positioning process is started immediately without the drive coming
to a standstill at the first target position.
v [m/s]
v
v
Sequence profile (C01307/1...15)
for profile linkage/following block control
A special feature is automatic advancing to subsequent profiles with and without velocity changeover.
For this purpose, the profile number of the desired subsequent profile (1 to 15) is simply set in the
parameter "Sequence profile" (C01307/1...15) of a profile.
After execution of the profile (target position reached), the set following (subsequent) profile is started
automatically. In this way, profile chains can be stipulated without additional control processes.
• If the profile parameter "Final speed" (C01305/1...15) is set to <> "0", there is a velocity changeover
• If "0" is set for the following (i.e. subsequent) profile, profile linkage does not take place.
• This function can be performed in all positioning modes.
From version 06.00.00:
TP profile (C01308/1...15)
Profile number of the profile (1 ... 15) that is to be executed after a touch probe has been detected.
• If "0" is set, there will be no profile stepping through touch probe.
• Only relevant for positioning modes with touch-probe.
Touch probe positioning ( 527)
From version 06.00.00:
TP source (C01309/1...15)
Selection of the signal source for touch probe detection.
• Only relevant for positioning modes with touch-probe.
Touch probe positioning ( 527)
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
pos
end
leading into the following (subsequent) profile at the set final speed.
L
8400 HighLine C | Reference manual
Target position
Final speed (in this case, not equal to "0")
Œ

t [s]
Basic drive functions (MCK)
Positioning
525