2.3.2
Change parameter settings with PC and Lenze software
The USB diagnostic adapter, for instance, can be used for the communication between the
PC (including the L-force »EASY Starter« or L-force »Engineer« software) and the controller,
see illustration. The USB diagnostic adapter is the connection between the PC (free USB
port) and the controller (diagnostic interface X6).
[2-3]
Exemplary constellation for parameterising the controller
The All parameters tab in the »EASY Starter« and the »Engineer« provides a quick access to
all parameters of the controller.
The given categories and subcategories correspond 1:1 to the menus and submenus of the
keypad:
Category
Subcategories
[2-4]
All parameters tab in the »Engineer«
Moreover, the »Engineer« provides a commissioning interface on the Application
parameters tab where you can commission the application in a few steps.
Detailed information on how to handle the »Engineer« can be found in the
integrated online help that you can call with the [F1] function key.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
Introduction: Parameterising the controller
L
General notes on parameters
43