8.4
Basic settings
8.4.1
Machine parameters
The motor end, among other things, is described by the machine parameters indicated
below in respect of the mechanics used.
Note!
Setting the machine parameters is a basic prerequisite for the operating modes
"Homing",
The more precisely the machine parameters are set, the better the results of
positioning!
For
TA "Table
tab headed Application Parameters on the dialog level Overview Machine parameters:
Tip!
You are provided with more detailed information on the machine parameters
"Gearbox
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
"Manual
jog" and "Positioning".
positioning", you can set the machine parameters in the »Engineer» on the
ratio" and
"Feed
constant" in the following subchapters.
L
8400 HighLine C | Reference manual
Basic drive functions (MCK)
Basic settings
475