O Terminals - Lenze L-force HighLine C 8400 Series Reference Manual

6 I/O terminals
This chapter provides information on the function, possible parameter settings, and
technical data of the input/output terminals of the controller.
In the »Engineer«, the input and output terminals are parameterised on the Terminal
assignment tab. To do this, go to the Control terminals list field and select the terminals
that you wish to parameterise:
You can find further information in the respective subchapter:
Digital input terminals
Digital output terminals
Analog terminals
Touch probe detection

Note!
The input and output terminals of the drive controller have already been
functionally assigned in the default setting ("Lenze setting"). The preconfigured
assignment depends on the technology application selected in
control mode selected in C00007:
• TA "Actuating drive speed":
• TA "Table positioning":
• TA "Switch-off positioning":
( 428)

Wiring diagram, assignment and electrical data of the input and output
terminals can be found in the 8400 hardware manual in the chapter "Technical
data".
• The hardware manual has been stored in electronic form on the data carrier
supplied with the 8400 drive controller.

Tip!
How you can alter the preconfigured assignment of the input and output terminals
is described in the chapter entitled
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
( 310)
( 330)
( 333)
( 343)
Terminal assignment of the control modes
Terminal assignment of the control modes
Terminal assignment of the control modes
"User-defined terminal
L
I/O terminals
C00005 and the
( 371)
( 401)
assignment".
( 351)
309